Search results

My garage floor needs some attention and i have been offered some vinyl flooring (hospital grade stuff welded) will this stand up to the job of a garage floor? cars / tools / oils etc i would need to screed the floor to smooth it out and get rid of hollows. would the standard latex stuff be up...

i have the same boiler and its doing a similar thing no water seems to be coming out of the over flow. all rads/pipe work is leak free when i refill the boiler with the blue tap something under the boiler starts to drip, it stops when the blue tap is turned off i will get the Prv valve...

thanks for the info, i thought it might have been asking alot maybe a re-think of the layout is in order

this is what i was after knowing. i just wanted to know if one RSJ with no supporting walls was plausible i thought someone on here may have done something similar and could tell me yes or defiantly no. If it was a defiant no then i could re-gig the plans to incorporate a supporting wall or...

i think i have come to wrong place for help Thanks anyway :)

you assume right. i am sure the roof would have caved in long ago with 90mm by 30mm purlings the point of this question was for me to gain some info from people who are more experienced with roofs than me. i don't want to waste my time and money paying an engineer to come out to tell me flat...

I am in the proses of buying a 1950's bungalow which needs total renovation. We want to change the layout completely as its not been thought out well (dark corridors etc) We also want to create storage space in the loft We need to remove all the walls, 2 of which support the purlings. The...

Ok so i need to remove and clean this. When i remove it will anything need replacing E.G washers etc What cleaning solution should i use? How long will the cleaning take? (will the boiler be out of action for more than day)

yes thats what i did do i need to clean the main exchanger (above the burners) or the small one at the bottom of the boiler (to-wards the back) if what i did didnt clean the the right bits of the boiler what did it do? and what was all the black sludgy stuff? :)

to flush the system i used a 20L tank / pump / filter / i used a flushing agent (fernox i think) that the plumbers merchant recommend (i explained what i was doing) i pumped the flushing agent mixture into where the boiler takes the cold water from, Then collected it from the hot water...

if the boiler was blocked would this affect the rads as well as the hot water? The rads have always worked perfectly. when i flushed the hot water side it was bringing out black sluddgy stuff, i flushed the system 3 times 1hour each time, could more flushing help?

i will give this a try tomorrow :)

thanks for all the help. when you say corgi need to come out do you mean a heating engineer who is corgi registered or someone from corgi?

the central heating flow pipe doesn't change temp when hot tap is run if i lower the flow rate to 5L in 2 mins the water temp stays steady and hot

just tested. 10L took 58 seconds. water temp was luke warm :cry:

I am having problems with my hot water. The water was running warm cold warm cold never hot :cry: My 1st thoughts where clogged heat exchanger so i power flushed it with limescale & sludge remover (hot water side and rads) The water now runs warm MAD HOT! warm MAD HOT! etc I have also fitted...

does the hot water constintly flow through the domestic heat exchanger or does it only flow when the hot water is turned on.

today I drained down the system and put in sentinel X400 sludge remover, its been in about 2 hours so far and there's no change to the water. after I refilled the system I had a look for the domestic plate heat exchanger (its at the bottom of the boiler at the back) I turned the hot water on...

hi chris could you please give me some advice on my boiler //www.diynot.com/forums/viewtopic.php?t=45623

Hi all I have a problem with my ariston euro combi. The prolem is with the hot water, If i turn the hot tap on fully the water will run hot cold hot cold. If i turn the tap down to a trickle the water will stay hot. Its taking 45mins to run a hot bath :( The combi is about 7 years old. i...