Search results

Hi, I am having some troubles keeping my house and rooms right temp. I have pre-plumbed cylinder, Mitsubishi ASHP and controller running a two zone underfloor heating setup. https://heating.mitsubishielectric.co.uk/ForInstallers/Documents/FTC4%20Cylinder%20Install%20Manual.pdf I have obtained...

Hi I have a nice oak round breakfast bar that is untreated. I want to treat it with something to protect it from water and staining. Can you recommend a product please? I also have a piece of oak sideboard that a bathroom sink is on that requires the same treatment. Thanks

Me no, the wife on the other hand probably. I think I may just have to put my foot down. Thanks all, i will go with this.

yeah thats almost it but with a triangular x-section instead would be ideal, thanks guys picky i know.

Thanks for the reply but yeah far too bulky and commercial. Just trying to run a few network cables up the corner of a room without the mess of putting them in the wall. The missus doesn't want square trunking. If I have to I will just mitre some wood and pin it in the corner, I was just...

Sorry, this could fit in various part of the forum, but i figured you guys and gals are the most likely to know. Does trunking exist that will fit into a corner of a room to provide a 45 degree finish? So the trunking would have to be triangular shaped to achieve this. if so where can i...

not sure what you call yourselves nowadays. Preferably someone active on here but not essential. Anyway I need to get my heating sorted baby on the way. Any one of my rads will get hot on their own so I know there is no blockage but with the system running I just cannot get the house warm...

i am with EDf in an EDF DNO area, they said when i had my meter replaced if i sourced an isolator then they guy would wire the tails in as it was not something they did themselves. Guy turns up fits my new meter and refuses to fit isolator they haven't supplied...

seagullsy see here for answer

tbh i didnt think that was a regulation....is that only in the OSG or a GN and not in the 17th? whatever the answer to my question it would seem sensible anyway so yes taking into account a 45% space factor what is smallest (workable) width oval conduit for a single 2.5mm cable. I guess...

what is smallest (workable) width oval conduit for a single 2.5mm cable

just some random thoughts why is there a how to and a wiki there are three different search boxes on this site (at least) forum wiki and homepage the latter really just gives you shop results (i realise you can turn this off but it is the default)? i guess its some legacy thing why not...

check out //www.diynot.com/pages/el/el054.php

how far do you allow a cable to run before you will derate the cable. most CU's i have seen have the cables incoming all bunched and should as far as i can see technicially be derated but i guess you use some common sense here and say if its less than x then dont bother? have i missed some...

march fools day they moved it a month early just for this occasion

thanks guys as usual you are all extremely helpful

ah, thanks. are there more? is there a list?

cables should, wherever practicable blah blah blah. ..... regulation 523.6.6 but there is no 523.6.6. am i going mad?

Im not angry its just hard to judge what people are thinking when reading text and so i cannot work out if this is a serious comment or not!? And i really hope it is someone having a laugh, but if its not please can you tell me the town/city so i never buy this house. if you are serious...

Erm, peter you seem to be missing the point of all of these posts. Implies you do not have a good enough understanding to perform this work. You then contradict yourself and just because you dont do gardening what about the poor green fingered lady that moves into your house...