Search results

Hi, I'm about to install a Techflow QT45-2 shower pump, and i'm concerned about the possibility of getting an airlock in the pipework run from the pump to the bath/shower mixer taps. It's all installed in the airing cupboard, the pump, CWS and HWC. The feed from the CWS will be direct downward...

Hi, I would appreciate any advice on this. I need to install a shower pump for my open vent system, it's all in a flat so I am investigating negative head pumps (CWS and HW cylinder are in the airing cupboard, no loft!!). However, i was wondering if I could still use a 'normal' pump (non...

Hi, I currrently have a 20 year old extractor fan, a big bulky noisy thing called 'Harmony' made by Greenwood Airvac, sitting in Zone 2 above the bath at the taps end... It comes on with the light switch, there is no FCU for it. . So i just got a Wickes Bath/Shower extractor fan 240v. In the...

Hi, i wonder if anyone here has a solution to this.. My 40mm waste pipe runs about 5m from the kitchen sink to the soil pipe, the fall seems adequate (approx 1 inch in every metre). After about 18 months of a new pipe install i had slow moving drainage (v.slow) so i decided to put in an access...

Hi, Would appreciate some advice, i have a conventional boiler that's over 20 years old now, and am planning to get a combi. I live in a 1 bed flat on the 4th floor, the current system has F/E tank, CWS about 1 metre off the 'ground' and the hot water cylinder that sits underneath that (so...

Hi, I've been reading this forum for a year or so and it has helped me greatly in fixing my place up. I've almost finished the kitchen, and before i do the tiling have a question... Is it against regulations to plug a washing machine AND my fridge-freezer into 1 FCU, using a 2-way extension...