Search results

Hi All, A simple question (I hope). I have a Drayton Tempus 7 programmer/timer. This has a switch on the back labelled 'Pumped --- Gravity'. Idea is with a Gravity fed DHW the HW circuit is supplied if the CH is on. However I have a C-plan control system set up with a 2-port MV in the...

Hi All, I have a Baxi Bermuda Inset 2 (Back boiler). I have just had the the Tempreature Sensor replaced and this has cured the problem I had with the boiler trying to start up but not lighting, going out quickly and trying to start up etc. (Its a Gravity fed DHW/Pumped CH in 'C' plan...

Hi All, Baxi Bermuda Inset 2 Back boiler. No air in system, checked. Room stat properly calling for heat. Pump running okay. Boiler fires up and goes out almost immediately. This repeats several times before it stops for a long while. Pilot does come on and one in several times...

Hi All, I have Baxi Bermuda Inset 2 Boiler 50/4E and Graivty fed HW/Pumped CH system. I have roomstat, BoilerStat and 2port Honeywell valve. System has been wired using Honeywell C-plan schematic. (Note the red spots indicate which positions are live under various conditions, above shows...

Hi All, I have a Baxi Back boiler 50/4E Gravity fed hot water paumped CH system with a two port (Honeywell) valve on the hot water return. Right that's the system, heres the problem. Timer 1 7am-9am Boiler fires up heating and hot water works fine swithces off at 9am no problems...

Hi People, I'm replacing some wall lights which are double earthed. (They are plaster uplighters.) I'm replacing them with metal/chrome fittings. These require an earth connection. The previous installer has trimmed the earth wires right back into the wall. So there is 'little' slack. I...

Hi, I'm new to this forum. I hope someone can help I have following 2 questions. 1) I have had a Patio door removed and a window fitted to replace it. This has involved bricking and blocking around and under the window. The room is plastered with base coat and top. The plasterer wants to fill...