Search results

have contacted Plumber who installed the system. Thankyou to all that were helpful in this matter. I will post when problems is cured. Sherbert, there are two issue (1) is cold water dripping through the tundish, (2) is water seeping out of the side and end of the plastic cartridge that is...

No idea how much the company charges and i dont get travel time or expences paid

To answer the question how much i would get paid for 20 mins labour, the answer is £6 and that is gross. That is why i think £50 is alot. I would of done it for my neighbour but she didnt ask.

Remember i only asked a question, if you don't want to answer it's fine. All the people that seem to be suggesting how costly it is to be self employed perhaps should go and work for an employer and see how much it costs. PAYE tax with NO allowances for anything, we still got vehicles to...

Hi Tony, didn't say i expect to be conned, simply said i want to avoid being conned. Old lady two doors away paid £50 for a tap washer job on her outside dripping tap two years ago. I started the thread with a question, that's all? I havn't accused anyone on here of anything, why would i as i...

Thank you Picasso, only noticed the issue Yesterday morning and have been trying to get hold of the Plumber who installed it but no luck yet. I will keep trying him until Tomorrow then i will consider your offer which is much appreciated. Do you think its safe to use for a couple of days with a...

Thank you for the Info and being Honest. In the Rodings, 8 miles West of Chelmsford.

Thank you for answering, for the back feed example you give what is actually at fault? If a plumber says i need a new Megaflow cylinder for example i wouldn't know if that is plausible, so just trying to know what to expect in my own mind Thank you.

Thank you for answering, i have open and shut the valve several times during the procedure for recharging the air gap today, also the continuous run of water is ice cold when i know the cylinder is hot. Would be good to know what the two valves on the mains inlet to the cylinder (in my photo's)...

I am not unhappy about anything but thanks for asking. If the first two lines of your last reply were applied then nobody on here would give or take any advise or help on anything Mick. If anyone can help with advise or information on the question posted i would be very Grateful Thank you

That's why this forum came about isn't it? i am a mechanical engineer and using reasonable intelligence and common sense we have to make our own choices in life. Personally i wouldn't touch the cylinder but changing an external valve or fitting which are compression jointed i think i am more...

Thank you Mick, i am aware of that requirement however i want to understand what's wrong to avoid be conned. I am sure you are aware of how tight money is at the moment.

Hi, i have a megaflow hot water and heating system about 12 years old, i have a constant drip/run into the funnel like overflow which is connected to the pressure relief valve. the mains inlet to the cylinder goes through 2 valves one 3bar then an 8 bar, there is a small pipe out of the side of...

pictures of megaflow installation