Search results

I have already had my engineer out, and he seems to think its the pcb, but he wasn't 100% sure. I am just trying to pick other peoples brains, as if it isn't the pcb then it's a waste of money

1.5 However, when it did go back to working the once, it went up to 2.5 and in the red. It has never gone above 2. When I switch it on, it doesn't fire up - you can hear the switches going, but nothing happens

when the boiler is switched on, the radiator light comes on to call heat, it then goes out, and the water light flashes, and the fault on fan or flue flashes, and we cannot get hot water, and/or heating (this happened last night) We switched it off, back on again a few times - nothing...

We have a Bosch EXXCEL silver dishwsher (probably 5 years old) and suddenly the water stopped being pumped through. Is this worth a plumber's job, or a new one!?

We had a blockage about six months ago and it flooded, but we cleared it. Now there is no water coming through the 'spinners' at all - the dishwasher is about five years old - is it time to replace?!!

Oh, I think we are getting out of our depths now. Without sounding rude I haven't a clue what you mean to do. MMMMMMM. I'm stuck! Also, we now have another problem (don't scream). The flame is igniting literally every three to four minutues, making a buzzing noise, then switching off...

Yes, the temperature light (70 C) flashes (the water symbol underneath). How do we measure the resistance of the sensor please? thanks

Hi Tony What we have to do, is use a pair of small pliers, gently grip the black plastic part that sits at the end of the wiring, and pull it out away from the actual sensor. The sensor remains in the boiler, but the wiring and connector are loose. As soon as we take this connector out, the...

Where would this be located please? - we have not got a clue where to start? thanks

No, I am not joking, this is the only way we can have heating on. Obviously this is only temporary until we can find a fix. I wonder if you can help - the PCB we originally ordered and tried (part number 248731), would not fit. Were we informed correctly that this part is now only made by...

I have used my Servis W/M twice since the first smell to see if the burning smell was a one off. It's not - after about five minutes into the cycle, a horrible hot electrical burning smell appears. The machine still runs perfectly through to the end of the cycle. It is not blocked anywhere...

OK. We are back to square one. What I meant to explain more clearly was, that we took out the DHW sensor completely and hey presto, the heating came on. This was just a temporary measure as we were cold. If we required hot water, we would put the sensor back in, then take out again after...

I don't pick the new one up until tomorrow - we know for sure that this will be the first time it has been repalced as we put this boiler in new three years ago. It isn't the flow switch as this has been tested and works fine. We have just taken out the DHW sensor and the heating works a...

Thankyou - is it still replacing the sensors aswell?

Solid

Thank you very much Baxpoti - we will give this a go and report back Jenny

thank you very much for your advice anyway - I think we may go down the route of the motorised 3 way valve being replaced, not sure. I am hoping Baxipoti will be able to help a bit more. Thankyou, Jenny

Right, we ran a couple of diagnostics last night and here is what we found: We have two dials that opertate the boiler - one dial turns on the boiler to either CH/HW, or just HW The other dial is for the HW Preheat When in CH/HW mode: CH radiator light on Turn taps on, rad light...

I will test later tonight and report back, thankyou.