g2-20

Hi all, I'm hoping someone can help me. I've recently installed a Honeywell G2-12 into my home. I've installed all the sensors and everything was working fine. Lastly I needed to wire the internal sounder (i've decided I don't require ta bell box at the moment). Whilst installing the internal...

Anyone know the wiring for a g2-20 and reson8? The more I’m looking the more I’m confusing myself? I’ve attached 2 images, one of the panel and one of the SAB. Any help appreciated. Image by Alroy1980 posted 1 Sep 2019 at 3:26 PMECC619A3-CE84-4F67-ABAF-5C6C8B0926F3 by Alroy1980 posted 1 Sep...

Hello On a Galaxy G2-20 under option 57 you can print system programming and diagnostic information to a serial printer from the program header. The installation guide states that you need a printer lead (part number A225) to do this. I have a few questions that I hope someone can help with...

Hi all - On a galaxy G2-20 I'm using an RF portal c079-2 , it's a model that uses tracks on the PCB for the antennae, and has a jumper with the 'russian' frequency option. There are 2 antennae, one vertical and one horizontal - and a jumper to select 'ant1' or 'ant1 & 2'. The jumper was...

Hi All, Does anybody have any experience with wiring up key switch zones on a Honeywell galaxy system? I seem to be stuck with getting this to work. Instead of an actual key switch, I want to use a relay to allow remote setting/un-setting. Looking at the manual, I need to change the...

Hi, I have a g2-20 panel installed and working fine until 2 nights ago, at about 4pm (14/11) 2 panic buttons leds started flickering red as if they had been pressed and the mk7 by the door has no display but the green led at the bottom is on, the panel is not in an alarm state or reporting any...

hi all I've recently purchased a galaxy g2-20 and I have a texecom odyssey xb bell box. I'm unsure of the connections. The panel has Bell + 0v T Bell pic (1003) Light pic(1004) Bell box has +12v (A) Bell (B) Tmp (C) Ov (D) Strb (S) Msw (1) Msw (2) Test (T) Tamper relay x2 Fault relay x2 Can...

Hi all, after perusing the forum and reading one article on the installation of the max3, I have followed the cabling and install as per the post and confirmed it with the install sheet that came with my reader, but I still can't get the reader to set and unset the system when presented with a...