Hey Everyone,
Currently fitting my recently delivered Howdens kitchen, in order for it to work down one side of the kitchen I have had to remove the service void (60mm) from all base units, I'm wondering if anyone has any advice on how to attach these to the newly dot and dabbed walls.
I'm aware the usual method is L brackets but now without the service void side panel protrusions on the back I can no longer use these.
I'm thinking maybe use a washer and and fix through the rear support that runs along the top above the thin back panel of the units?, sure it would be visible on the inside but I can't think of a way to avoid that.
Any feedback is much appreciated.
Currently fitting my recently delivered Howdens kitchen, in order for it to work down one side of the kitchen I have had to remove the service void (60mm) from all base units, I'm wondering if anyone has any advice on how to attach these to the newly dot and dabbed walls.
I'm aware the usual method is L brackets but now without the service void side panel protrusions on the back I can no longer use these.
I'm thinking maybe use a washer and and fix through the rear support that runs along the top above the thin back panel of the units?, sure it would be visible on the inside but I can't think of a way to avoid that.
Any feedback is much appreciated.