Hi
I'm replacing the toilet cistern valve which is well past it use by date with a Torbeck Ecofil bottom entry valve.. The new Torbeck connector is shorter than the original by 5mm so i need to do a small amount of plumbing work to re-connect the cold feed.
The pipe size is 15mm so i thought I could use a flexible connector from the isolating valve to the valve inlet. I've had a look at screwfix but I'm unsure what i need. Would a standard tap connector do it if I connect it to a stub of pipe coming off the isolating valve. Ideally if it should had a nut at either end I could connect direct to the isolator.
Hope this makes sense.
All help appreciated...
This is what needs replacing:
I'm replacing the toilet cistern valve which is well past it use by date with a Torbeck Ecofil bottom entry valve.. The new Torbeck connector is shorter than the original by 5mm so i need to do a small amount of plumbing work to re-connect the cold feed.
The pipe size is 15mm so i thought I could use a flexible connector from the isolating valve to the valve inlet. I've had a look at screwfix but I'm unsure what i need. Would a standard tap connector do it if I connect it to a stub of pipe coming off the isolating valve. Ideally if it should had a nut at either end I could connect direct to the isolator.
Hope this makes sense.
All help appreciated...
This is what needs replacing: