Hi All
Probably a real simple answer but I'm stumped so thought I'd ask on here.
Currently fitting a dual fuel towel rail, all is ready but when I fit the element and the dual fuel adapter, the heating pipe inlet is in the wrong position. It has no wiggle room to tighten it up another half turn and doing a half turn less leaves it very loose.
It's a single threaded adapter so not a case I can just Retry and pick up a second thread.
Any ideas what I can do to overcome this? Do they have adjustable versions or different size threads so it would turn another half turn?
Suggestions appreciated.
Cheers. Karl.
Probably a real simple answer but I'm stumped so thought I'd ask on here.
Currently fitting a dual fuel towel rail, all is ready but when I fit the element and the dual fuel adapter, the heating pipe inlet is in the wrong position. It has no wiggle room to tighten it up another half turn and doing a half turn less leaves it very loose.
It's a single threaded adapter so not a case I can just Retry and pick up a second thread.
Any ideas what I can do to overcome this? Do they have adjustable versions or different size threads so it would turn another half turn?
Suggestions appreciated.
Cheers. Karl.