Hi all,
I thought this would be a more appropriate place to post than the Electrical Forum.
I am currently renovating my bedroom and required to replace the mounting box for the switch in the room to a deeper one, however, the filler used to 'make good' has not set on the left-hand side:
I have used some regular filler and some finishing plaster left over from another project, however, both had failed to set.
I have thought about using some 'Lightweight filler' or if that fails, then Sand-and-cement.
What advice would you give to me to get this completed easier and ready-to-decorate at the end of the week?
Thanks in advance.
Kind Regards,
Andrew
I thought this would be a more appropriate place to post than the Electrical Forum.
I am currently renovating my bedroom and required to replace the mounting box for the switch in the room to a deeper one, however, the filler used to 'make good' has not set on the left-hand side:
I have used some regular filler and some finishing plaster left over from another project, however, both had failed to set.
I have thought about using some 'Lightweight filler' or if that fails, then Sand-and-cement.
What advice would you give to me to get this completed easier and ready-to-decorate at the end of the week?
Thanks in advance.
Kind Regards,
Andrew