Hello
New boiler fitted Flexicom SX30 system boiler only heating radiators, (replaces a Baxi 105E combi).
Everything works no fault codes, no lock out.
The water temperature is set to 80C and max power is set to 30KW, from a cold start the temperature gauge rises slowly and after about 4/5 minutes the tpi room thermostat turns off (in anticipation) yet the 30kw boiler has only managed to get the water up to about 50C and the return is not much more than warm.
Eventually all rooms get to temp after a few cycles but it is a lot slower than the Baxi.
The Flexicom is a fully modulating boiler, it will go down to about 10KW, and I suspect it is doing this despite the settings.
Perceived problem is only on start-up.
So is there anything wrong? or is this just the way it is? I would expect full tilt at 30KW and THEN modulate down.
Thanks
New boiler fitted Flexicom SX30 system boiler only heating radiators, (replaces a Baxi 105E combi).
Everything works no fault codes, no lock out.
The water temperature is set to 80C and max power is set to 30KW, from a cold start the temperature gauge rises slowly and after about 4/5 minutes the tpi room thermostat turns off (in anticipation) yet the 30kw boiler has only managed to get the water up to about 50C and the return is not much more than warm.
Eventually all rooms get to temp after a few cycles but it is a lot slower than the Baxi.
The Flexicom is a fully modulating boiler, it will go down to about 10KW, and I suspect it is doing this despite the settings.
Perceived problem is only on start-up.
So is there anything wrong? or is this just the way it is? I would expect full tilt at 30KW and THEN modulate down.
Thanks