gardtec 360
- Thread starter britprac
- Start date
Sponsored Links
I find your question a bit odd. If you remove the sensors from an alarm system, it won't work. What did you think would happen? You need to put them back on the new door.
When you removed the sensor did you write down the colours ?
Are they surface contacts or flush ?
If you have another door contact on you system go and see how that is wired.
If the new door is upvc then the contacts need to be no more than 6mm apart for a surface contact.Do not fit a flush contact
Are they surface contacts or flush ?
If you have another door contact on you system go and see how that is wired.
If the new door is upvc then the contacts need to be no more than 6mm apart for a surface contact.Do not fit a flush contact
Did you leave the magnet on the old door? Have you connected the resistors the right way?
Sponsored Links
Resistors ? On a gardtec 360 ? No ....lol
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
