Hi folks - I'm a newbie to this forum, so please be gentle!
The boiler is an old but trusty Trianco oil-fired job, sited on the ground floor of a single storey extension - pump, motorised valve & cylinder are mounted above in Y plan format. I've just updated these with a Danfoss FP715SI controller.
Distribution to the rads passes up/down/everywhere thro stone wall into the main part of the house.
In general the nightmare of pipework seems to deliver the heat to the right places, but it all needs to be tidied up - which is underway.
One of these pipes is a 15mm vent from the top of cylinder that eventually makes its way to the CW cistern, with many twists and turns.
My question is - is it possible to replace this with a T into a 22mm feed to a remote bathroom that runs direct from top of the cylinder, thro the wall & below the cistern? The T would be about 1m below the cistern water level.
cheers
The boiler is an old but trusty Trianco oil-fired job, sited on the ground floor of a single storey extension - pump, motorised valve & cylinder are mounted above in Y plan format. I've just updated these with a Danfoss FP715SI controller.
Distribution to the rads passes up/down/everywhere thro stone wall into the main part of the house.
In general the nightmare of pipework seems to deliver the heat to the right places, but it all needs to be tidied up - which is underway.
One of these pipes is a 15mm vent from the top of cylinder that eventually makes its way to the CW cistern, with many twists and turns.
My question is - is it possible to replace this with a T into a 22mm feed to a remote bathroom that runs direct from top of the cylinder, thro the wall & below the cistern? The T would be about 1m below the cistern water level.
cheers