- Joined
- 24 Aug 2009
- Messages
- 2,660
- Reaction score
- 280
- Country
Hello
Unsure if above is clear, but my problem is that , after buying and installing a new hand-basin in the WC, I found that the bottom boss was badly cast at an angle and it was impossible to get any kind of a seal when screwing the female half of the plug assembly onto the basin.
As already on wall, didn't want to take off and return ( long way to store as well ) and so used angle grinder to flatten/level boss. It is now close to level but still leaking: I don't want to continue with the grinder in case I go too far and there is not enough thread on the assembly to allow me to fit two washers.
If I apply silcone to the boss and screw up onto that, would you expect that would give me a seal that would hold permanently?
Thanks in advance
Unsure if above is clear, but my problem is that , after buying and installing a new hand-basin in the WC, I found that the bottom boss was badly cast at an angle and it was impossible to get any kind of a seal when screwing the female half of the plug assembly onto the basin.
As already on wall, didn't want to take off and return ( long way to store as well ) and so used angle grinder to flatten/level boss. It is now close to level but still leaking: I don't want to continue with the grinder in case I go too far and there is not enough thread on the assembly to allow me to fit two washers.
If I apply silcone to the boss and screw up onto that, would you expect that would give me a seal that would hold permanently?
Thanks in advance