Come on all you experts. How do you drill a 1" hole in tiles to pass a shower feed pipe through. Is it a series of small holes or is there an easier way. Thanks all for your help. Graham.
i normally drill a series of small holes. its best to site the tile on a soft but firm surface like an old piece of foam backed carpet. the "give" in the carpet helps stop the tile from splitting.
Thanks noseall, I shall probably do as you suggested. As for the reply from confused. Can I get a 1" masonary bit? and I would have thought that it would cost rather a lot and would not prove cost effective to drill one hole. Thanks anyway both. Stratman.
Sorry yes I suppose it would be expensive just for one hole, If you were anywhere near me [Yorkshire ]you could borrow mine, ask around friends. good luck.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local