hi, my White Knight Sensordry with Reverse tumble that Noah built has stopped spinning. well, almost stopped spinning. you can spin the drum by hand and it feels ok with regards to the bearings and motor turning freely. i removed belt and turned motor and drum again by hand, all good. i plugged it back in (with belt off) and the motor is just about creeping around when the timer is operated. there is also a loud noise(cant think of correct word) but it sounds like a motor being loaded up, sort of electrical inductance? (i get a simlilar noise on forklift truck drive motors when driving them slowly). ive turned it off and reset timer several times and fault still the same. can anyone tell me what to do next? im thinking of fitting a new capacitor- can get one for less than a fiver. the timer switch is closer to fifty quid. probly more than the dryer is worth, unless a museum fancies buying it any suggestions gratefully excepted bearing in mind it wont physically fit where some of you may suggest