My Whirlpool ADG 7560 Starts Cycle Then Beeps As If Finished After About 3 Minutes. It appears to start makes all the usual noises but just stops. I have tried the test cycle as discussed in other posts & it appears to flash in a 5 pattern. PS i have cleaned the filter & poured boiling water into the filter hole
Have also Isolated The Door switch To Observe What Happens. The water rises from the filter tray the pump sounds like it is pulsing, then water starts from the central spray bar for a couple of minutes. Stops then the water is sucked away & the machine beeps as if completed
Any ideas!
Have also Isolated The Door switch To Observe What Happens. The water rises from the filter tray the pump sounds like it is pulsing, then water starts from the central spray bar for a couple of minutes. Stops then the water is sucked away & the machine beeps as if completed
Any ideas!