Hi all,
Don't know if there is a genius out there that can help but here goes....
I have a Zanussi DA6141 Dishwasher. Over the last few weeks, it seems that the programming isn't working properly. If you set it to run on a basic or intensive cycle, then it starts to go through it but after a couple of minutes it stops what it's doing and thats it. You get nothing more. This happens in 3 out of ten attempts to get it going. Usually when this problem happens, it won't even get to the filling up bit. Just stops dead in it's tracks and wont go any further at all.
Any ideas?
Thanks very much.
Don't know if there is a genius out there that can help but here goes....
I have a Zanussi DA6141 Dishwasher. Over the last few weeks, it seems that the programming isn't working properly. If you set it to run on a basic or intensive cycle, then it starts to go through it but after a couple of minutes it stops what it's doing and thats it. You get nothing more. This happens in 3 out of ten attempts to get it going. Usually when this problem happens, it won't even get to the filling up bit. Just stops dead in it's tracks and wont go any further at all.
Any ideas?
Thanks very much.
