well i set the two zones of the keypad to numbers 11 & 12 all seems fine but they have not been "seen" as when i have the zones open, the panel sets ok and when they are closed after panel sets it doesnt go into alarm when i open the zone, is there a step by step guide for mapping the zones?
i pick the keypad (no.4) press no, set the zones to 11 & 12 press yes to store set the zones up as guard etc but nothing
think i have worked it out in my head, may go back to the job tomorrow, the two zones off the keypad have four terminals and i have wired it "normally closed" with the tamper in one pair and the zone in the other, this i thinks needs to be set up as "double pole" i think at the moment both the tamper and the zone needs to be open to cause an alarm
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local