Wiring Bell Box to Accenta GEN4 Panel

Hi,

I am wiring up a new panel from an existing bell box and have the following outputs from the bell box and am proposing to wire to the GEN4 panel as follows:-

Bell -ve wire to B
Bell +ve wire to D
Strobe -ve wire to Strobe -ve
Strobe +ve wire to Strobe +ve
SCB 0 wire to A
SCB rt wire to T

Does this sound correct, particulalry the order of the last two?, as the GEN4 manual only seems to indicate 5 connections to the bell box and I have six?

Any advice greatly received.

Thankyou

The strobe + isn't required as it is linked inside the sounder. You only need the stobe -.