Hello, I wish to wire the following items to my scantronic 9751 panel.
2 pyronix Deltabell plus external sounders.
1 pyronix internal speaker/sounder.
Please correct me if i'm wrong but do each of the outputs (OP1-OP3) on the 9751 panel provide 500mA each?
In that case I should be able to connect 2 ex. sounders without problems.
However i'm not sure on the sounder connections for BELL & STROBE. Do they connect to OP1 & OP2?
(I will link T feed to -12v on first bellbox, then T return from bellbox one to tamper feed on bellbox 2. Finally Tamper return from bellbox2 to TR terminal on Panel).
Re; Pyronix twin alert, its an internal speaker & sounder in one unit. It has connections for 12v+ & 12V-, SPK & BELL (Neg trigger) & draws 160mA.
Can I connect SPK to LS terminal, and BELL to OP3 on panel,rather than to Ex. sounder BELL Output, as this would be overloading the bell Output. Connection this way would mean the Unit will give speaker tone on normal entry/exit, and will become sounder in event of alarm, when OP3 is energised on alarm.
Thank you
2 pyronix Deltabell plus external sounders.
1 pyronix internal speaker/sounder.
Please correct me if i'm wrong but do each of the outputs (OP1-OP3) on the 9751 panel provide 500mA each?
In that case I should be able to connect 2 ex. sounders without problems.
However i'm not sure on the sounder connections for BELL & STROBE. Do they connect to OP1 & OP2?
(I will link T feed to -12v on first bellbox, then T return from bellbox one to tamper feed on bellbox 2. Finally Tamper return from bellbox2 to TR terminal on Panel).
Re; Pyronix twin alert, its an internal speaker & sounder in one unit. It has connections for 12v+ & 12V-, SPK & BELL (Neg trigger) & draws 160mA.
Can I connect SPK to LS terminal, and BELL to OP3 on panel,rather than to Ex. sounder BELL Output, as this would be overloading the bell Output. Connection this way would mean the Unit will give speaker tone on normal entry/exit, and will become sounder in event of alarm, when OP3 is energised on alarm.
Thank you