can any one help sometimes when i use finishing plaster i get tiny air pockets that i cant get out, is it because pva is too strong or weak or not mixed plaster enough ?
plastering
- Thread starter hyde
- Start date
Sponsored Links
sometimes, if a backing coat or float coat of bonding or browning hasn't had enough time to go off (set) then due to the water trapped in the plaster and the lack of suction, this can cause "bubbling". usually a good grind with the trowel, just as the skim is setting gets rid of this.
- Joined
- 28 Oct 2005
- Messages
- 31,282
- Reaction score
- 1,998
- Country
Leave your skim coat longer before going back to trowel it flat. There is a certain stage when the skim is just going off when it is 'spongey' and the more you mess with it the worse it gets. Leave the skim coat about twice as long and then go back to it.
joe
joe
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
