Wonder if someone can advise on how to utilise the low voltage light relay on an Amerec AT5 Stream generator controlled by a T100 Touch control
Aparently to can switch a light on with the controller. I have no experience working with relays.
The relay has 2 connections NO and COM See pic.
Also a link to the manual
There is no wiring guidance in the instructions and I am a bit lost
How does this set up work and how would you wire it
Thanks
http://www.amerec.com/Files.aspx?f_id=57965 View media item 80298
Aparently to can switch a light on with the controller. I have no experience working with relays.
The relay has 2 connections NO and COM See pic.
Also a link to the manual
There is no wiring guidance in the instructions and I am a bit lost
How does this set up work and how would you wire it
Thanks
http://www.amerec.com/Files.aspx?f_id=57965 View media item 80298