Hotpoint 9934 washer/dryer

Joined
25 Mar 2005
Messages
2
Reaction score
0
Country
United Kingdom
My Hotpoint washer sticks and overheats on all programs except quickwash (6). Have changed the module, and fitted new thermistor. (Rubbishy push-in connectors on replacement thermistor, but seem to make adequate contact) Still overheating! Anyone got any ideas? Thanks.. :(
 
Sponsored Links
I think on these machines the heating is controlled by switching the timer to a non heating segment rather than directly switching the heater element. It could therefore be a mechanical fault such as stripped gear teeth in the timer. This is a case where the DIY approach can work out more costly than paying a repair man to do the diagnosis and just replace the faulty part.
 
Thanks Fido. I'll check it out. Fortunately the spares were not too expensive, but a timer!? :cry: FltEng
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top