Texecom Com2400

SteNova · 9 Jan 2011

I've got a texecom prem 24 v8.25 all working fine

but i've tried to add a com2400 and it can't get it to work,
connected it to the 10pin header, not got the cable connected (com2400 manual said it wasn't needed) set it to com1 as stated in com2400 manual
wired to phone line via an adsl v1.0 filtered faceplate on the 2 & 5 connectors,
enabled it on the RKP but when i make a test call it disconnects the other phones so it can see the line, but i get no text
if i pick up a phone connected directly into the faceplate when it is ment to be working it's just dialtone

anyone got any ideas??

Alarm · 9 Jan 2011

is it alligned correctly?
Did you downpower everything when you doid connect?

SteNova · 9 Jan 2011

yes it's all sitting square on the pins etc, it was powered down, battery off, all phone connections done with faceplate off master

aptsys · 10 Jan 2011

I still had to connect the cable to the COM1 or COM2 header on the main PCB for mine to work despite it saying it wasn't required.

Alarm · 10 Jan 2011

#Just looked , where does it say "do not use header lead"?

Connect it, see what happens.
I think it may grab the line fron the 8/10 pin connectors telling it but it still needs the trigger inputs from the lead.

aptsys · 11 Jan 2011

I think it was included with the Com2400 on a separate bit of paper for versions built after a certain date.

Alarm · 11 Jan 2011

Well in this case it would seem it needs it.

RF Lighting · 11 Jan 2011

I'm sure I had to connect a lead from the com1 socket on the main PCB to the Com2400 to get it to work on my panel.

SteNova · 13 Jan 2011

i did try it with and without

can anyone confirm working settings for the com port setup?

RF Lighting · 13 Jan 2011

Have you got your phone number programmed in?

Have you got a number programmed in for the SMS centre? Mine is set to primary : 07860980480
secondary : 07785499993

Have you told com1 that you've fitted the digi to it?

Have you set ARC 1 protocol to SMS messaging?

Don't forget to select the option "reset digi" after you've made alterations to the digi, before attempting a test call.

Just a few things to try.

SteNova · 13 Jan 2011

will try those things at the weekend, should be so simple to set up but i just can't get it working, done loads of sd2/3's in work no probs

Alarm · 14 Jan 2011

SD`s are a bit different.
Thats like saying a Galaxy Dimension is just an alarm panel.

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Texecom Com2400

Alarm

Alarm

Alarm

Alarm

Similar threads