I have finished all the wiring of my Premier 24 with 11 PIR wired (EOL) expander, 2 keypads and speech dialer.
I have managed to remove ALL alerts on the keypad, Bell Tamper, & Auxiliary Tamper.
I have done a walk test ALL OK
I have done a bell test ALL OK
The problem I now have is that the alarm will not arm, although it goes through the motion but after 1 minute it has still not armed.
On the main keypad the "ARMED" "READY" "BYPASS" lights are flashing this keypad is set with the engineers keypad address. The 2nd keypad is showing no errors.
Is this a programming error or a wiring error?
I would really like to sort this out, but I am loosing the will to live?
Safe Dave
I have managed to remove ALL alerts on the keypad, Bell Tamper, & Auxiliary Tamper.
I have done a walk test ALL OK
I have done a bell test ALL OK
The problem I now have is that the alarm will not arm, although it goes through the motion but after 1 minute it has still not armed.
On the main keypad the "ARMED" "READY" "BYPASS" lights are flashing this keypad is set with the engineers keypad address. The 2nd keypad is showing no errors.
Is this a programming error or a wiring error?
I would really like to sort this out, but I am loosing the will to live?
Safe Dave