INDESIT WD12

1969stuc · 28 Jun 2005

TWO YEARS OLD. WAS MAKING ARKING NOISE AND STRUGGLING TO SPIN.TOOK A LOOK AND FOUND THE BRUSHES WERE WORN. HAVE REPLACED THESE AND RUNNING FINE. ALTHOUGH NOW THE DRUM IS MAKING ALOUD RUBBING NOISE. TOOK THE BELT OFF AND IT IS COMING FROM THE DRUM. NO SIGN OF RUST FROM BEARINGS. ANY IDEAS. SHOULD I STOP USING.

MOD

you may wish to peruse item 6

bathjobby · 28 Jun 2005

STOP SHOUTING

Is the wife missing a bra wire ? Probably something got stuck between drum and case, have a close look inside drum at all the holes, if your lucky it may still be in hole and you can get it out. If not take the drum out and look, if this is clear then only bearing left.

1969stuc · 29 Jun 2005

THANKS: BUT NO BRA TO BE FOUND AND NONE MISSING.
IT MAKES QUITE A DEEP NOISE, ALRIGHT WHEN SPINNING SLOW BUT ABIT NOISEY WHEN FAST. TRYED TO UNDO BIG STAR SCREW ON THE BACK OF THE DRUM CANT BUDGE IT. DO I NEED TO UNDO THIS TO REMOVE DRUM. ANY TACTICS FOR UNDOING IT.
CHEERS
____________________
moderator

please see 6 this is your 2nd warning

nigeld · 30 Jun 2005

am assuming this machine has stainless steel outer tub(some have plastic) large torx screw is in centre of pulley for removal of pulley only.if you want to remove this youl have to heat with blowlamp-to change bearings tub needs to be lifted out of top of machine-not for diy suggest you scrap machine

1969stuc · 1 Jul 2005

Thanks everyone. I,ve stopped shouting now false of habbit.
I am still using the machine. It is no worse , i will wait for the bang.

mgb129p · 4 Aug 2005

I've got exactly the same problem - is this a common problem with Indesit washers? I've previously always had Hoover machines which seem to last at least 10 years. The Indesit isn't even 2 years old yet!!

________________________
moderator

please note 17

bathjobby · 4 Aug 2005

is this a common problem with Indesit washers?

Not in my experience. My current Indesit is 10 years old and going strong.
The previous Indesit lasted 20 years. I did change the bearing after about 14 years, but by that time almost everything else had been changed too.

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

INDESIT WD12

Similar threads