I have fitted new bath mixer taps and have replaced fibre washers. When i replaced washers i noticed i asnt replacing so much as adding as there were no washers in to replace. My problem is the cold tap pipe is leaking just a little over the join. It is a little drop oozing through about every couple of hours. If i wipe the join it takes several hours before anything appears. Is there any other way anyone can think to stop this?
Fitted bath taps
- Thread starter loozit
- Start date
Sponsored Links
since checking the old taps more thoroughly i have discovered that the people who installed them has apparently put foam around them and this has broken down so it could be that there was a leak all along. I moved in here 7 years ago and the people who "refurbished" the flat before i moved in were cowboys so i would not at all be surprised if this problem has been ongoing.
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
