Hi
I have completed an install of a Gen4 system and have an error when I try to set the system..it says 'setup fault 2 hall' and then for every zone which are
1. front door final entry exit
2. hall PIR on final exit
3. back door ... mag contact
4. lounge ...pir
5. utility ... pir
6. 2 further doors ... mag contact.
I am thinking this is a set up problem and wondered if anyone could post an example of how to set up a zone or zones with configuration above...thanks in advance..
I have completed an install of a Gen4 system and have an error when I try to set the system..it says 'setup fault 2 hall' and then for every zone which are
1. front door final entry exit
2. hall PIR on final exit
3. back door ... mag contact
4. lounge ...pir
5. utility ... pir
6. 2 further doors ... mag contact.
I am thinking this is a set up problem and wondered if anyone could post an example of how to set up a zone or zones with configuration above...thanks in advance..