I am reaplcing the bathroom in a new build property and have decided to fit a run of LED plinth lights to teh bath panel and the furniture plinths next to it.
I was planning on extending the cable from my overhead ceiling spots (as the cable runs down into the bath head box for an alcove spot), but that means that the LED lights only switch on when all the ceiling spots are on, would prefer to leave on when spots off.
To wire a new separate light circuit, switched from outside bathroom door also seems excessive for 10 LEDS.
Anyone any advice on how LED plinth lights can eb switched on and off - I beleive the lights will be ZONE 0 as wiring in bath panel and plinth, Mains to Transformer could also be in Zone 0 (under bath), so any separate switch perhaps could be on low voltage side of transformer, but that means transformer on 24/7.
I was planning on extending the cable from my overhead ceiling spots (as the cable runs down into the bath head box for an alcove spot), but that means that the LED lights only switch on when all the ceiling spots are on, would prefer to leave on when spots off.
To wire a new separate light circuit, switched from outside bathroom door also seems excessive for 10 LEDS.
Anyone any advice on how LED plinth lights can eb switched on and off - I beleive the lights will be ZONE 0 as wiring in bath panel and plinth, Mains to Transformer could also be in Zone 0 (under bath), so any separate switch perhaps could be on low voltage side of transformer, but that means transformer on 24/7.