Hi all
We had a level ball value fail today on the hot side (sealed system, mains pressure). It leaked between the joint that holds the two parts together. The first image below shows a side that has a small gap and its here where the water came out.
The second picture show the other side where there is no gap and it looks tight.
I thought it was crossed threaded but the gap doesn't look wide enough for it to be so.
This has been live for 9 months without an issue.
Any ideas ?
Toby
Side that shows gap.
Other side, no gap.
We had a level ball value fail today on the hot side (sealed system, mains pressure). It leaked between the joint that holds the two parts together. The first image below shows a side that has a small gap and its here where the water came out.
The second picture show the other side where there is no gap and it looks tight.
I thought it was crossed threaded but the gap doesn't look wide enough for it to be so.
This has been live for 9 months without an issue.
Any ideas ?
Toby
Side that shows gap.
Other side, no gap.