Hi. I have a PARKSIDE table saw (bought at Lidl) model PMTS 210 A1. (It's actually made by Scheppach). The blade is dia. 210mm, bore dia., 30mm, 2.6mm kerf, 24 teeth. Riving knife thickness 2mm, max speed 7000 min-1. I was cutting wood then saw sparks, so I stopped. I have the impression (from some read) that I could probably cut through a few nails without wearing out the blade significantly. However, I though maybe I should buy a "nail proof" wood cutting/multi-purpose blade when cutting wood with nails in it.
On that score, I am looking at Evolution R210TCT-24T (Rage) Multi-Material TCT. It's 210mm dia., 25.4mm bore dia., but nothing said about kerf. So, I am wondering, if I got a reducer, would this blade make a good choice for my table saw. So, would it? Or, should I go for some other blade? Thanks. Rich
https://www.amazon.co.uk/gp/product/B0084281SO/ref=ox_sc_act_title_1?smid=A3P5ROKL5A1OLE&th=1
EDIT: Not sure of rpm of fitted blade.
On that score, I am looking at Evolution R210TCT-24T (Rage) Multi-Material TCT. It's 210mm dia., 25.4mm bore dia., but nothing said about kerf. So, I am wondering, if I got a reducer, would this blade make a good choice for my table saw. So, would it? Or, should I go for some other blade? Thanks. Rich
https://www.amazon.co.uk/gp/product/B0084281SO/ref=ox_sc_act_title_1?smid=A3P5ROKL5A1OLE&th=1
EDIT: Not sure of rpm of fitted blade.
Last edited: