I am looking at fitting a Drayton Wiser 2 channel system to our boiler - which is a condensing boiler of type Gloworm Ultracom 30 hxi
The Drayton documents make it sound like an easy swap.
However, looking at their manual, it is not clear to me how that maps to the Gloworm manual (section 10):
https://www.wolseley.co.uk/wcsstore...l/ti/on/Glowworm_UltracomHXI_Installation.pdf
The boiler is wired into a 2 gang box, which then runs off to a British gas wireless receiver, a valve, and a pump. I /think/ the Drayton heat hub would go in place of the british gas wireless receiver...but not certain!
See image below:
https://ibb.co/2NHyYYg
There is also a unit with controls, which I am assunmingi s is taking power from the 2 gang box, but comms is wireless to the wireless receiver....and would become redundant after installing Drayton.
Can anyone offer any advice as to whether this will work before I splash out on the Drayton kit?
Cheers!
The Drayton documents make it sound like an easy swap.
However, looking at their manual, it is not clear to me how that maps to the Gloworm manual (section 10):
https://www.wolseley.co.uk/wcsstore...l/ti/on/Glowworm_UltracomHXI_Installation.pdf
The boiler is wired into a 2 gang box, which then runs off to a British gas wireless receiver, a valve, and a pump. I /think/ the Drayton heat hub would go in place of the british gas wireless receiver...but not certain!
See image below:
https://ibb.co/2NHyYYg
There is also a unit with controls, which I am assunmingi s is taking power from the 2 gang box, but comms is wireless to the wireless receiver....and would become redundant after installing Drayton.
Can anyone offer any advice as to whether this will work before I splash out on the Drayton kit?
Cheers!
Last edited: