Installing my kitchen sink, this is an inset sink but struggling to see how the overflow will fit thru worktop cut out.
The overflow sticks out under the sink further than the rim of the sink and there is only a gap on 15mm between top of overflow and underside of sink rim.
If I cut the opening for sink large enough to accommodate the waste overflow the rim will not cover the hole all round.?
The overflow sticks out under the sink further than the rim of the sink and there is only a gap on 15mm between top of overflow and underside of sink rim.
If I cut the opening for sink large enough to accommodate the waste overflow the rim will not cover the hole all round.?