Recent content by Adam135

  1. A

    Remeha Boiler Not Firing Up

    Will look for a pressure sensor but going from the book it doesn’t mention one. Noticed the last few days that the pressure has dropped for example. Topped up to 2 bar and next day or 2 it’s down to approx 1.7 bar. Boiler is off as property is being renovated. Could this indicate a problem...
  2. A

    Remeha Boiler Not Firing Up

    Yes I saw it says theres a lack of water/pressure, however neither should be the issue as boiler has been topped up to 1.5 Bar. Few radiators were removed and refitted. Boiler then refilled and radiators bled. Appears theyre not as common anymore. Is there a pressure sensor as I'm looking at...
  3. A

    Remeha Boiler Not Firing Up

    Hi, after some advice on my boiler please, Remeha Avanta 28c. Boiler was switched off whilst house was being renovated, was working fine before being turned off. Radiators were drained/removed during this however pressure gauge was stuck which turned out to be faulty, replaced with a new one...
  4. A

    Remeha Boiler - Central Heating Goes Cold When Hot Water Tap On

    Thanks for the replies everyone. Love it lol! Yes I did run the water continuously! I wasn’t actually using the heating as to heat the house I was rather testing the boiler! As it’s a recent house I moved into and the boiler wasn’t working at the start and now that it is i left everything...
  5. A

    Remeha Boiler - Central Heating Goes Cold When Hot Water Tap On

    Hi, I have a problem with the following boiler and was wondering if someone could shed some light on it: Its a Remeha Avanta 28C. The hot water works fine all the time. When the central heating is turned on the heaters will get warm perfectly fine. However when the hot water tap is used the...
  6. A

    Damp Problem

    Couldn't edit that last post, Just to be a little more clearer.. Would the sleeve extension extend the air brick horizontally, so that the vent would fit in the wall? Or is that extension for the vertical length going downwards?
  7. A

    Damp Problem

    Would these angled vents provide enough air, bit unsure due to the bend in them would air be forced into the cellar? In the picture of them, there shown to be attached to a wall that is only 1 brick thick/wide, as the property im wanting to put them on is much thicker than 1 brick, would...
  8. A

    Damp Problem

    I understand a dpc is applied above ground level. The cellar walls are underground therefore the way to cure them would need either tanking slurry or membrane? But how or what would be applied to the wood floor joists that run across the wall? The joists don't go into the wall, they are...
  9. A

    Damp Problem

    Thanks appreciate the reply. I actually tried to tank one wall myself, this resulted in the wall staying wet with visible droplets on it. Im pretty sure i followed the instructions right but it didnt seem to work. Having a quick read of wet rot or dry rot it seems as if there is both...
  10. A

    Damp Problem

    Hi fellas, id be grateful if someone could give me a bit of advice with a damp cellar. Long story short, old building with a closed cellar since built by a concrete floor. Concrete floor wood and steel support became rotten which meant it had to be replaced. It was replaced with a wood floor...
  11. A

    Blocked Sewage Pipe

    Think i just worked it out, i dont think it needs to be cleaned. About 3 weeks ago the fence in the back card blew down, its the neighbours fence, thats because when he changed the fence a few years ago he didnt change the poles, so he put up a new pole few weeks ago which looks longer than...
  12. A

    Blocked Sewage Pipe

    How much would that cost?
  13. A

    Blocked Sewage Pipe

    Hi, recently my sewage pipe has started to get blocked. The water fills up in the box outside and water starts to overflow onto the garden. Its happend twice in the past 2/3 weeks, and now is going to happen for the 3rd time. Unblocked it first time with drain rods, was fine for a week...
  14. A

    Eaglerise Transformer, SET60CV

    Hi, i have two wall lights in my living room, both have the SET60CV transformer in them. Both have stopped working. Looking around iv found a relpacement eaglerise set60cv for £15 on ebay. But iv noticed people on here suggesting using Aurora AU-RD60 But nobody has actualy said if they...
  15. A

    Touch Light Switches.

    Dont actually know what fluroscents are, But okay, Oh Thanks For That Reply, Ill wait for his reply and see what he says also, Also, Has anyone evere used these with G U10?
Back
Top