Recent content by adw99

Hi thanks for your help Had a friend of a friend out the expansion vessel is fine (phew £230 plus need to remove the boiler from the wall to replace) seems to be the pressure release valve is the likely suspect but there was a bit of head scratching swapping of bits. PRV scrapped and cleaned...

Hi please could i ask for some advice on a problem we have. We have a Glowworm 30Ci combi boiler. Unit was working fine then the pressure dropped down to 0, we can't find any leaks inside the house, no water stains or drips anywhere. All pipework run in upstairs floor voids. We refilled...

Thanks for the advice ill get the part. What would cause the restriction of flow through the dhw plate exchanger if i change the disconnector will that just be a short fix or is there anything else that needs looking at.

Hi I tried the filling tap when i got home fully closed tight I opened it closed it again i then tried letting some water through topping up the pressure to 1.0 bar then put a bit of tissue on the shelf below so far it hasn't dripped again since ??? Is it worth getting a replacement...

Thanks I'll check that when i get home. If the filling tap was left on / open even just a little bit ie enough to cause the boiler to discharge the excess, wouldn't the pressure have risen above 1.0? Cheers

Hi Ive left it overnight no lose in pressure; (bucket under the boiler). Not a lot of water but enough. any thoughts as to why the pressure has remained at 0.9? Could you guys suggest places for parts, that you've used before and like. Thanks

Boiler

Thanks The pressure is 0.9, i assumed that a very small drop from 1.0 was just evaporation but it constantly dripping. I haven't topped it up for ages and wasn't aware it was leaking but it must have been for some time but the water has gone down the back of the cupboard I read the manual...

My pressure reducing valve is dripping constantly slow but steady Is this just a faulty valve or is there anything else to be aware of? Any suggestions for where to get spares? Thanks in advance for your advice

Thanks guys BES have what I need once again thanks for the info

I did but there is no infor on where to get these items in the UK thank you for your helpful reply

Hi can anyone tell me where I can get extra long (5m) inlet and waste pipes for a washing machine, or where to get the connectors to link shorter ones together? Cheers Andy

Hi can anyone tell me where I can get extra long (5m) inlet and waste pipes for a washing machine, or where to get the connectors to link shorter ones together? Cheers Andy

Hi am looking for the same stuff would anyone be kind enough to help the thickie how you connect the pipes and where you can get the connectors Cheers ______________________________ lynda, moderator post locked to prevent hi jacking