Recent content by andymg09

Used the command 21 and it seems like the system was set to CC+Com A/T. I set the system to 8 fully supervised loop zone (FSL 2K2/4k7) and tried to walk test the system and now nothing is being detected. The key pad display is set to Walk Test but when I open/close doors with sensor it does not...

Weekdays are quite busy for me so I'm going to try out the suggestions over the weekend! Appreciate all the help.

Initially when I replaced the battery no resets or defaults were performed. But I was still getting the zone flt error. So I recycled the system and also did reset of the code so that it defaults to the usual code and I'm still getting the same error. Are you saying I need to reprogramme the...

Eeek! wasnt expecting to disconnect everything - Never done it and is bit scary. To confirm do you mean disconnect wires CCT1-CCT7 from the main board?

Apologies for the late reply, I have now been able to replace the fuse and I'm still getting the same Zone flt Z01-Z07 error. Is there any anything else I can try?

Got the meter delivered today. The voltage is around 13.20 v measured at the connector at the board. Aux voltage is around 13.35v o.n both the points. The guy who sold me the battery said after charge the battery should measure around 13.20v. If the board is spiked would you expect the...

Alright so not to worry about the comm port. It seems like the fuse must have blown off in past so as a quick fix they wound some wire around the fuse. When I did the access code reset, in the log I saw message about global tamper so that must be the case. I have ordered a multimeter, once I...

Thanks, I think I will have to get someone in to look at the same. The comm's port is disconnected. I assume this is because the system is no longer under maintenance?

Yes, it looks like someone has put fuse wire around the battery fuse. I have no idea what rating it is. Unfortunately I have inherited the system with little details on what work has been carried out till present. But the result of walk test etc is all fine, do you think there is some other...

I took a picture as I was not too sure which connection you were referring to. Hope this helps at all, if not than please point me to the right direction. PS: I found that couple of cables are clipped not sure if they broke off or if they are meant to be like that i.e. unconnected.

When I entered 21 in the system it says 21:CC+Com A/T. I also have some installation notes left by the Alarm company (PFS). It says Zone 1 (Front door) 2.3 ohm, zone 2 (Lounge) 1.8 ohm, zone 3 (Kitchen) 1.9 ohm, zone 4 (Rear Garden door) 1.9 ohm, zone 5 (Dining room) 1.7 ohm, zone 6 (1st Floor...

Thanks for the reply. Just to confirm, I can check the detail by entering 21 in the installer mode? (Didnt want to screw the system up further :roll:)

Currently I have a Scantronic 9751 Alarm system with 9930 LCD remote keypad. The software on the system is v02.01. My problems started with the system showing Battery flt i.e. Missing battery and Unit battery Low power message. This was due to the battery being 10 years old :roll:. Anyway, I...