Evening all,
After having the heating on for a couple of months now, I've noticed a drop in system pressure - 1 bar down to 0.25 bar. Along with this, I've noticed the rads on the middle floor (of 3) are not heating up.
This evening, I went round and bled the 4 rads and a lot of air came...
In a sealed system, should there be any pressure difference between system running (hot) and system off (cold)?
My system heated by an ideal classic ff250, operates hot at 2 bar. But whenever the system shuts down the pressure drops down to 1 bar within about 1 hour. Is this normal?
I have an Ideal Classic ff250 with a small crack in the heat exchanger which is causing a small leak - 1 or 2 drips per minute - when the system is cold.
Question is, is it worth trying Fernox F4 as a first fix?
I've got a small crack in my Ideal Classic FF250 heater exchanger which leaks (1 or 2 drips per minute) when cold.
Before I go for a heat exchange replacement, I thought I would give a leak sealer a go. Question is, which is the best? Fernox F4?
P.S. Boiler is 12 years old, heat exchanger 8...
My fan has just started to make a nasty humming/squeling noise everytime the burner kicks in which quietens down after a minute or two. It has started to do this a day after a small crack in the heat exchanger was identified, (repair pending), but can the small leak / slight pressure drop cause...
I've just got the same problem. Boiler will not start up when hot water is selected. Took the cover off the Honeywell zone valve and noticed the valve has motored over correctly and microswitch has made, (clicked). Only when one of the microswitch wires was wiggled, did the pump and boiler...