Recent content by au8830

I'm glad you posted this, because it prompted me to have another look at my TF1 Total. Earlier in the year I had all new radiators and pipes but kept the old boiler and the TF1. I started to get air in the system (I expected some initially after refill) - with it seeming to get worse each day...

I have the Drimaster 365 model, so it runs all year round, and in the summer it moves a diverter flap to pull in air from outside, rather than the attic. I'm not convinced it actually makes that much difference compared to a standard Drimaster running in the mode with the >23C limit disabled...

I can't speak for dehumidifers (never tried one), but I was in a similar position as the OP, with a 2-bed bungalow, except that I already had an extractor hood in the kitchen, a bathroom extractor, condensing tumble dryer and I made use of the night vent lock position on the windows. Between...

I just re-read what I wrote, not clear. :oops: It's not completely uninsulated; the original pink insulation runs right to the edges of the ceiling, up to the wall plates, but it's only about an inch thick. There isn't enough height to get the full depth of insulation into the gap between the...

I went to a local company, pretty much the same price as online, cut to size, MDF reinforcing. They lent me a stack of uPVC sample swatches - lots of variations of white/beige - and one of them matches pretty much perfectly. In hindsight pure white from eBay would have looked horrendous - I...

Hi, I currently have fully glazed uPVC front door with mid-rail, along with matching side panels, total width 2.1m. In the summer, the hall gets extremely hot. In the winter, it's cold (but this is less of a problem). I'm looking into replacing the lower panels with solid panels...

I have a early 1970s bungalow, with typical low pitch roof. The tiles are interlocking concrete tile (look like Marley Wessex) and there is black "felt" underneath. The timber soffits and fascias do not have any visible vents. Under the last row of tiles there is some kind of plastic moulding...

Silicone did the trick. 8)

In my bathroom, I have a Roper Rhodes New England basin with Roper Rhodes Insight mixer tap. I have noticed that water is able to get underneath the sink through the tap hole (i.e. water that has already been run out of the tap correctly, and has either been splashed onto the basin, or...

Thanks, that's the direction I was leaning.

For a continuous run of units, with a tall larder cupboard stepping down to a sink unit, would you put a full height end panel on the side of the larder unit, or just from the worktop to top of larder unit?

I have a small 2 bedroom bungalow with limited ventilation provision and I'm currently experiencing problems with condensation running down the double glazed windows. The windows do not have trickle vents, and I have been using the "lock open" position 24/7 to mitigate the problems, but don't...

Thanks for your reply. It was built 1970/71. I would like to think (but have not proven) that there is a separate DPM if only because the black tile adhesive hasn't been applied to the edges of rooms (although the tiles were), nor was it tiled underneath kitchen cupboards (bare concrete).