Recent content by bhota

Cheers for clearing that up. Thanks Sparky

Hi there everyone. I have a Accenta 8 mini system, when we have the odd power cut the the alarm does not activate as it should. Anyone know why this is, it used to before until i changed the internal 12v battery. The alarm itself works fine. :D Even if i hold down the tamper button and remove...

Ok problem fixed, bloody one of the sensors was loose from its casing and was triggering the alarm due to the spring in the sensors, hence the tamper alert. All working fine now. Thanks again for the help.

Thanks for the help Sparkymarka. Took out tamper wires from terminals 19 & 20 and also T & A terminals(tamper bell), once powered back up, tried resetting but no good, keypad still shows tamper and wont let me reset it. Even disconnected the tamper terminal for keypad but still the same. When...

accenta8 mini, was playing up last week all zones were lighting up when i tried to enter code and would not let me set the alarm. Solution was changing the internal 12V battery, everything was working fine for 3 days then alarm just went off by itself, entered the code and it switched off but...

Hey thanks to Europlex & Scott1980, the problem was the battery, got new battery cost £9. Working absolutely fine now. Was quoted by some alarm company £50 to solve the problem & £20 call out charge. Saved £60 for a 2min job. Thanks again guys.

Thanks for the reply, the battery has not been changed since 2000. If that is the case, i believe its an easy job to do? I was hoping that a fuse had blown, but as i said all fuses are fine but all other people who have encountered this issue have all said they changed a blown fuse, so you...

Thanks for the reply, the battery has not been changed since 2000. If that is the case, i believe its an easy job to do? I was hoping that a fuse had blown, but as i said all fuses are fine but all other people who have encountered this issue have all said they changed a blown fuse, so you...

Once code is entered all zones 1-8 light up except zone 2 on keypad, none of the pir sensors light up, i believe thats the problem, checked fuses inside the control box and all fuses are fine (checked with multimeter and all beeped) Even checked each sensor to see if loose wiring but everything...

Same problem , once code is entered all zones 1-8 light up except zone 2 on keypad, none of the pir sensors light up, i believe thats the problem, checked fuses inside the control box and all fuses are fine (checked with multimeter and all beeped) Even checked each sensor to see if loose wiring...