Recent content by bigwood

Thanks for the help. I have actualy noticed the hot tap runs cooler if you put it on full flow. I was told that this because the boiler cant keep up with the output from the tap. A gas man told me this when he serviced the boiler, I thought at the time he was trying to be clever but not being a...

As mentioned a while ago I am re-building my bathroom, starting next monday. Whilst looking at what will be required for the plumbing side of things I noticed the hot feed to the bath taps is 22mm to the tap. The cold is 15mm with a step up to 22mm for the tap fitting. :? I know there was a...

I have already mentioned the re-build in else wear in the forum but this is the full plan. We have green bathroom sweet that is looking very dated, an over bath shower that causes water to run down the hall walls. And some one has put a wooden dado rail half way up the walls including in the...

:) Thanks for the help. I have had a look at what is supplied with the tank. The fittings are plastic screw thread so I agree with the ruber washer and not much efort to tighten. As the tank is consealed in the vanity unit I asume it is supported by the flush pipe as I cant see any suports built...

As in the title I am about to re-build our bathroom. This will include a vanity unit. So far I have found only one thing that has me a little conserned and probly silly so I will ask on here so no one can see me asking silly questions. :oops: The fitting for what I would call the ball cock...