Recent content by boulter

I have water penetration in my hallway about 4ft below the velux in the picture. It looks like water is running off the side of the copings then down the rendered wall. Therea about 5mm gap at some points between the underside of the copings and the wall. There is a round drip off but the end of...

I have water penetration in my hallway about 4ft below the velux in the picture. It looks like water is running off the side of the copings then down the rendered wall. Therea about 5mm gap at some points between the underside of the copings and the wall. There is a round drip off but the end of...

Thanks for your suggestions makes sense to go from the right -my only other idea was to go from right and left and have a triangular section where both sides meet but mabye wouldn’t look the best in the middle ?

Thanks for your advice -the main door in use is the door on the top left beside the emergency exit-the double doors will be used less but the parcels area will also be fitted with carpet tiles. I was thinking right to left as this will be the bigger section then infill with diagonals. Ive...

Hi I’m planning on laying carpet tiles onto the plan attached photograph? Where is the best place to start as they are going to meet on the angle as the room is not rectangular? The floor is concrete painted with floor paint will the Tackifier be ok on this? Thanks :)

I was hoping for another 100 years from it as most of the tiles are good! I just need to stop the water coming in though. Would a new roof help stop the wind tunnel in our hall as there is no felt under the slates & all the plaster has fell off!

Hi Ree 1 Noticed the water after after heavy rain recently when it came into our bedroom & tripped the electrics by running into the ceiling light switch but the crack in the wall has been there for a year. 2 been in the loft but it's so close to the edge of the roof Its too narrow to see. 3...

Can anyone see from photos where water is coming in down wall into bedroom & into light fitting. Thanks (y)

Thanks for your reply. The programmer is a Sunvic TLX rfp with wireless programmable room thermostat. Boiler fires up with flow light when tap opened so can I assume flow switch is ok? and when heating is on, storage tank heats up to set temp on dial so tank stat should be ok? The tank...

It's a Boulter Camray 5 oil combi boiler.(2001) When heating is on shower and bath are hot but if I use the shower during the day when heating has not been on it quickly runs cold after a minute. Boiler and hot water dials are set to 3/4 way round. Heating works fine. Could it be the Sika...