Recent content by buildersam

Hi, please find attached picture of the wiring diagram. regards, Sam

Many thanks for your response, did as you instructed and is all sorted now. I wondered if you could help me with this other on going problem I am having, once the alarm has gone off, entering the user code stops the internal sounder but the outside bell carries on until it re-sets itself after...

Hi all; I wondered if anyone can help me, whilst repositioning a PIR at my home the electricians short circuted the power supply to this and blew the 0.5A Aux fuse on the alarm panel, I have since replaced this and all PIR's are now working but since then the keypad screen has been flashing and...

Thank you, this seems to be the answer to all my problems!!so I can now connect other devices to the trigger head and simulate alarm condition without the outside bell operating. but will the strobe be functioning? and internal bell sounding? during this 10 min. delay. regards.

Thank you very much for your help, the internal bell needs 380mA. so have now changed to output 1003 and all is working. Is there a way of live testing the system with the outside bell disabled? without disconnecting any of the wiring to the outside bell. regards,

Thank you, I am not on site today, will check on Monday, I am sure output 1003 is set to Bell Latch +ve , as the outside siren works.

Hi, can someone please tell me how to connect an internal sounder that activates at the same time as the outside siren to my system. I am using a Honeywell internal sounder and have tried the following combinations without any luck: +ve sounder to +ve Aux , -ve to speaker output. +ve sounder...

Many thanks for your reply, is this true of all outputs, i.e. they only supply the negative to whatever is connected to that output?

Can anyone please tell me how to connect an internal sounder to the system? I have tried the speaker output on the panel with no joy and have also tried using the trigger output on the panel by programming the outputs with no joy, any help will be greatly appreciated.

Thank you, I have linked the -ve to AL in the PIR and then connected it to the 0 on the panel. So only three wires going to the panel.

Thank you for your reply, can you tell me if this is correct: seven connections on the PIR: T,T,AL,EOL,AL,(V-),V+ I have connected: T to zone on alarm panel resistor across other T to AL resistor from AL to other AL and then negative to -ve on the panel +ve to +ve on panel is this...

Hi, can someone please tell me the correct way of wiring PIRs. I am using Honeywell PIRs ,problem I have is on tamper only the internal siren sounds and do not get full alarm, is this because I have wired the detectors incorrectly or is it an option setting somewhere? Help is much appreciated...

Hi I have just learnt that my usual supplier has gone in to liguidation, can anyone please tell me where is the best place to buy alarm supplies, I am after MK7 keypad, battery and PIRs. Help is much appreciated. Sam

At the moment to access the keypad I click on the short cut for the programme on my desk top once the Jar file has run I then open a new page with the explorer and type in http://localhost and then I am on. I don't know enough about it to be able to create a short cut that would do the whole...

Thank you for recommending the LCE module, I have installed it on my system and it works a treat! unfortunately there is not an app for iphone but that is not a major problem as I intend to buy a cheap android phone. I have been trying to make accessing the panel a bit easier with the software...