Recent content by carl150

Thanks for all your advice, the boiler is on a switch, so can we cross that of ?. Is it usual when I reset the trip the electric to stays on for a while ?

A few weeks ago I reset a cable into the wall , yesterday took it back out to check I hadn't gone through it with the galvanised channel looks ok. The boiler is on the circuit but I isolated it (took out fuse). No spurs coming of the circuit.

The RCD is tripping, the only way to get back on is to turn of the breaker for downstairs sockets.

Hi Woke this morning electric had tripped , reset on board found to be downstairs sockets circuit the problem, unplugged all appliances still tripping checked all sockets they look ok, swapped fuse with upstairs circuit and its still tripping, sometimes stays on for a few minutes.

Thanks Dan fixed followed the pattern of the jumpers of the old pcb and Hey presto we have heat and hot water Many Thanks

We had no manual Dan with the pcb . The chap of ebay must have sold 40 + all with positive feedback I thought it was a case of swapping over. Which pins need setting up ?

Hi Dan no haven't set up the jumper pins , just bought replacement box of E Bay. Any ideas how I would set them up ? Thanks

Hi just replaced the pcb on my ideal isar boiler the problem is H 5 is flashing up no hot water or heat ! Looked on a few sites and they talk about jumpers if these are the connection that push in then they all seem pushed in. Any replies would be greatly appreciated...