Recent content by colly1964

I have just purchased a new acrylic bath and it does not have the tap holes drilled in it !!! Whats the best drill bit to use and are there any tips that I could do with knowing before turning on the drill.... Cheers....

Bongos.... Thanks for the reply/advice... i had considered the other types of shower (mixer/power) but my hot water is run off a combi boiler which when hot produces about 9 ltrs a min in the bathroom area but at a low pressure i was concerned that there would not be enough hot water...

Advice required if at all possible.. background.. currently refurbishing my bathroom and about to replace my old shower (Electric shower 8.5kw gainsborough about 10yrs old) supplied by a 6mm cable 10/11metre run from consumer unit (40amp RCD) to pull switch. 2metres of cable from switch to...

Advice required if at all possible.. background.. currently refurbishing my bathroom and about to replace my old shower (Electric shower 8.5kw gainsborough about 10yrs old) supplied by a 6mm cable 10/11metre run from consumer unit (40amp RCD) to pull switch. 2metres of cable from switch...