Recent content by corgi del

Check the pressure of the expansion vessel. Should be around 1 bar. Push in the needle of the schrader valve, if water comes out the vessel needs replacing.

I wonder what other corgi installers think about the Corgi plumber scheme being available to non corgi men.

Hi all, I have been following the power flushing debate with great interest. Last wednesday I was called to a breakdown on a Glowworm 24i (absolute piece of crap). I was the fifth plumber to look at it. I don't know why the others couldn't sort it, but that's another story. Anyway, the prv...

Jdey?? Who are you?What are you talking about. It sounds like you are Polish. You can't even write in English correctly. What's all this that, that ,that . Why don't you go back to your Polish **** hole and get a local peasant to sort your plumbing out for two cows and food voucher.

You need a megaflo.

The cold main should always feed straight to the boiler. Don't forget that all hot water and cold draw offs ultimately come off the main. work it out. Basic plumbing ;;; pressure and flow. It's not just about joining pipes. Call a professional.

Use a washing machine self cutting tap with a half inch hose. Afterwards fit drain off to T where hole is.

If there is a blockage between the feed and vent the boiler overheat stat usually trips.

Personally I would do away with the F/E and fit an expansion vessell.

The pump is sucking water in from the feed and pushing out of the vent. Move the pump to the other side of the pipes and reverse the feed and vent order.

Are the feed and vent pipes both(together) on the flow or return pipework?

If its not the cylinder or the boiler temp too high, then it must be the pump position. Where do the feed and vent pipes connect? Are they 150mm apart?

What about on speed 1

Does the water stop when the pump is off?

Could be cylinder coil. If the F/E is lower than main storage cistern and water comes from expansion vent when pump is off then its the cylinder. Turn off supply to main cistern and see if level falls. I.E if the water coming out of expansion vent is coming from main cistern then it must be...