Recent content by Crox616

Thanks :lol: I am penny pinching but times are tough

to keep the cost down I am considering fitting a pre owned boiler. any issues I need to be aware of if considering this? :?

It was £1300 for the J&S water heater and new storage tank. I went for an instant gas water (second hand) and installed it myself then had it certified by a gas safe engineer. sold the scrap tank and pipework for scrap and used this to offset the cost of the engineer. Still looking at...

like you said nothing hi spec about it. I am looking at fitting a radiator system but want to do it cheaply. Why can't I reuse the existing flue? What boiler models are vertically flued

I am looking at replacing my Johnson Starley J50 heating system. Is it possible to fit a boiler in the place of the current unit and use the existing flue which is routed through the house to the ridge outlet. Most modern boilers appear to come with balanced flues directly through wall at...

Hi I am looking at installing a woodburner in our lounge. I intend to route the flue through the attached garage then up through the roof of this garage. I need to know how high does the flue have to project above the roof line? Also as the garage is attached to the house, does the flue have...

more energy efficient to heat water as I need it. also hoping this will be a cheaper solution as i wont need to replace the hot water tank.

Hello just casting about for some advice. I am looking to replace my current hot water system (Direct Electric Immersion) :roll: I have gas warm air heating and have been quoted £1300 for installing a water heater on to this system. this would however still mean I have a hot water storage...

soory for the delay got this sorted ok anyway.

I have a UPVC door with a split spindle. I want to replace this with a solid spindle as I find it annoying having to use the fy to open the door all the time. Is it just a straight swap over to a solid spindle? :?: