Recent content by Douglas Sey

...is this image visible? - where will I find the diaphram washer that is possibly causing my cistern noise problem? thanks again.

As you can see this an old cistern, 1.where exactly is the diaphram washer located? 2. how do I set about changing it? Thanks in advance - Douglas

My new plan is to take the whole track down and simply rewire a single spotlight. There is enough uncoiled flex at the base.

Yes, there is coiled flex between the three spotlights. How does that make a difference to cutting the one bad light off?

This left spotlight, one of three, has broken. It's very old and thus unlikely to be replaceable. Is it safe to cut this flex off and tape up, allowing the two remaining lights to work.

thanks, that sounds like an easier solution.

Could I not just hammer down these two protruding nails a little, then fit new tile with a thin nail acting as a tingle as shown on other tiles in photo?

Is this tingle just a bent nail, or something special. Thanks

How is it that following the recent storms, I am left with this gap and two exposed nails protruding approx 1.5cm. Do I need to drill two holes in a new tile to accept these nails? Thanks