So in answer to the question, yes Parameter A does exist on the HRE SB although it's not mentioned in the manual. In fact there is a lot not mentioned in the manual.
However with following setup it's possible to get a W Plan working, in this case with a Nest:
Parameter 1 =1 (Heating and DHW...
I have a question regarding an Intergas system boiler. The boiler has the ability to control a diverter valve using pins 5 and 6 on X2. The normal mode of operation is to open the diverter valve to Port A for CH. Can the boiler be configured to open the diverter to Port A for HW? So that with...
I assume your open vent version doesn't have a pressure switch that cuts the boiler if the pressure falls below around 1 barg. In my case I do and that is simply a open or closed contact across terminal X9, pins 5 and 6. I also wanted to stop the boiler in the event of the condensate pump...
It's taken well over a year for me to get around to drawing this up, but I thought it might be useful for others to put down on paper my setup for an Avanta 18S boiler with an unvented cylinder and iSense RF. I've based my diagram on those provided by Remeha for other systems.
The key...
The Rapido T valve is very well engineered and way better than a lot of the shiny 'designer' s**t that you can buy. Google RB Supplies and it should be fairly obvious what plates go with the valve. I found them helpful.